“ Originally Posted by TVDinner 
”
Thanks for the quick response. I shut the Fuze off and turned it back on again and was able to bring it back to the non TF3D screen (see attached image).
I would like to avoid hard resetting if possible. How do I "take the tab off" as you suggested above. I have learned how to install, but what is the easiest way to remove. Thanks.
how was it installed? was it a cab file or did you install through the touchflo 3d config tool? if you did it cab wise go to start/settings/system/remove programs. if you did it through the config tool than just to it opposite of what you did to getr ti there... most likey unchecking it.