[del33t]

OK...

Just completed my first flashing of my Mogul (PPC-6800SP)

I followed all the D/\SH's instructions on flashing to a custom from a stock ROM.

I used this ROM Kaos Mogul Hybrid Take 5 wm 6.1 gps & Reva

Everything seems to go well.

to flash a custom rom from a stock rom
1. unlock your phone using hardspl found here:
Did this and followed the steps

It unlocked (Red, White, Blue Screen)

2. download the custom rom of your choice and download
3. take the nbh file and drag into the RUU folder found here:
4. connect to activesync

Did this, I now have around a 66MB file called RUU_signed.nbh

5. run the romupdateutility.exe file from the RUU
6. follow the steps of the wizard.

It installed. The status bar on both my PC and my phone was in sync as they both reached 100%. It rebooted. Was stuck on the first Splash Screen (The Radio Splash as its called in this thread). I waited like 20 mins for it to continue. So I removed the battery and waited 1 minute or so and put it back in then Hard Reset it. It is still stuck at the Radio Splash Screen. . It boots a little bit because the boot numbers appear at the bottom of the splash screen then go away then nothing...they are...

M 09 P ACAAAAM-4070
B 03 R 1.32.00
D 3.56

I am hoping I did not kill this phone. I was looking forward to getting rid of Nextel and the ancient POS that I am using. If theres any hope please help

:crying:

7. DONE.

--------- New Post Merged on 22/12/2008 at 03:16:45 --------

Found this as a response to someone having the same issue...so I will try this.thanks!

Don't worry, you haven't bricked it yet. Which unlocker did you install? If you put the Mogul into bootloader mode (hold down power and camera buttons while pressing the stylus in the reset hole until you see a multi-color screen) it will tell you which bootloader (also sometimes called unlocker) you have installed.

If it is 2.40, leave the Mogul in that screen, plug in the USB cable, and run the OEM Sprint 3.35 ROM package on your PC. Ignore the wording about Activesync. That will give you compatible ROM, radio, and bootloader.

If it shows 1.20 in the multi-color screen, you installed the old version of the unlocker, and you will have to flash the OEM Sprint 2.17 ROM package to get a compatible ROM and radio for that bootloader. This is the part where you might brick the phone. If that works OK, you can then install the proper 2.40 unlocker and reflash the OEM 3.35 ROM package. If, however, after flashing the 2.17 ROM the phone goes into a dark screen and nothing will wake it back up (this is bricked), take it back to a Sprint corporate owned store or Repair Center and tell them it will not turn on, they will replace it for you since your previous posts imply that you have the TEP.