4th side cube

[bondsingh]

i tried the fourth side cube for the first time. i didnt like it bc i dont want to do any reg editing. prior to that i downloaded the cube configuration tool. its not bad but not sure how to replace new icons. so those were the only two things i downloaded recently and here is what happened. after trying the fourth side and deciding to uninstall it, i just could not remove it. i went to uninstall and deleted the cab, soft reset and soft reset but nothing. i had to do a hard reset...which i hated to do bc its a pain to get reinstall my tom tom program.

so i was wondering dash...since you made it,,any suggestions on which cube to choose that is the most stable and easy to configure w/o any reg editing. meaning i would like to have an icon describing the designated program. ive read your other posts about downloading brn files and etc....but i dont understand what to do w/it. where would i place it? do i still have to use the cube configurator to perform the task??? thanks

[D/\SH]

Originally Posted by bondsingh

i tried the fourth side cube for the first time. i didnt like it bc i dont want to do any reg editing. prior to that i downloaded the cube configuration tool. its not bad but not sure how to replace new icons. so those were the only two things i downloaded recently and here is what happened. after trying the fourth side and deciding to uninstall it, i just could not remove it. i went to uninstall and deleted the cab, soft reset and soft reset but nothing. i had to do a hard reset...which i hated to do bc its a pain to get reinstall my tom tom program.

so i was wondering dash...since you made it,,any suggestions on which cube to choose that is the most stable and easy to configure w/o any reg editing. meaning i would like to have an icon describing the designated program. ive read your other posts about downloading brn files and etc....but i dont understand what to do w/it. where would i place it? do i still have to use the cube configurator to perform the task??? thanks

sorry to heaqr bout the troubles you are having. havent heard this from anyone else so dont know what the problem could be for you. once you get a brn file you save it to your storage card or place of choosing than use the cube config tool to add that image for where you want it to go. thats all there is to it. i hope that this helps a lil for you and all. hit me up and tell me if it does.